Replacing a Splendide® Drain Pump

How to Replace a Splendide® Drain Pump

The drain pump is responsible for removing water from the drum during the drain cycle. When the pump becomes clogged or damaged, the washer may leave water in the drum or fail to complete cycles.

Replacing the drain pump is one of the most common repairs for **Splendide washer-dryer combos.

Tools You May Need

Before starting the repair, gather the following tools:

  • Screwdrivers
  • Towels or container for water
  • Replacement drain pump

Step 1: Disconnect Power

Always disconnect power to the washer before performing any repairs.

This prevents electrical hazards during the repair process.

Step 2: Access the Pump

The pump is typically located behind the lower front access panel of the washer.

Remove the panel screws to expose the pump assembly.

Step 3: Remove the Old Pump

Disconnect the hoses and electrical connectors attached to the pump.

Remove the mounting screws and carefully remove the old pump.

Step 4: Install the New Pump

Install the replacement pump in the same position as the original component.

Reconnect hoses and electrical connectors before securing the pump in place.

Step 5: Test the Washer

After reassembling the washer, restore power and run a short cycle to verify that the washer drains properly.

Back to blog